FAO LED Stunt Drone Instruction Manual - Important Battery Safety and Usage Guidelines (2024)

The LED Stunt Drone is a remote-controlled drone designed forusers ages 14 and above. It features LED lights and various stuntcapabilities. Please read all warnings and instructions in theinstruction manual before using the drone. The artwork and designof this manual are protected by US copyright law.

Contents:

• LED Drone
• Drone Controller
• 4 Replacement Propellers
• USB Charger Cable

General Warnings:

- Choking Hazard: Contains small parts. Not suitable forchildren under 3 years.

- Adult assembly and a Phillips screwdriver are required forbattery installation.

- Do not make any changes or modifications to the drone withoutexpress approval, as it may void the user's authority to operatethe equipment.

- Fly-aways are the responsibility of the individual pilot andwill not be replaced by the manufacturer.

Product Usage Instructions:

1. Prepare for Flight:

Prior to flight, follow these steps:

1. Install remote batteries (refer to page 4 of the manual).
2. Charge the drone batteries (refer to page 4 of themanual).
3. Ensure both the drone and remote are powered off.

2. Pair Your Drone:

Before each flight, pair the remote with the drone by followingthese steps:

1. Turn on the drone and place it on a flat, level surface.
2. Turn on the remote.
3. Push the left stick up and then down.
4. Repeat steps 1-2 if necessary.

3. Calibrate:

Calibrate the drone as per the instructions provided in themanual.

4. Remote Control Overview:

The remote control features various controls and functions:

• SPEED: Adjust the speed of the drone.
• STUNT: Perform different stunts with the drone.
• LIGHT EFFECT: Control the LED light effects.
• F TRIM: Fine-tune forward trim.
• AUTO ORIENTATION: Enable or disable auto orientation mode.
• LIGHT ON/OFF: Turn the LED lights on or off.
• TAKE OFF: Initiate takeoff.
• B TRIM: Fine-tune backward trim.
• LAND: Initiate landing.
• EMERGENCY STOP: Immediately stop all drone movements.
• ON/OFF: Power on or off the drone.
• R TRIM: Fine-tune right trim.
• L TRIM: Fine-tune left trim.

5. Operating Drone:

Follow these steps to operate the drone:

Step 1 - Pre-Flight Checklist:

1. Read all warnings and instructions.
2. Install remote batteries (refer to page 4 of the manual).
3. Charge batteries (refer to page 4 of the manual).
4. Make sure that the drone and remote are powered off.

Step 2 - Choosing a Location:

Select a suitable location for flying the drone, ensuring aclear and open space.

Step 3 - Lift Off:

Follow the instructions provided in the manual to initiatetakeoff.

Step 4 - Flight:

Use the remote control to maneuver the drone, perform stunts,and control the LED light effects.

Step 5 - Landing:

Initiate landing using the controls on the remote.

For further instructions and information, refer to the completeuser manual.

File Info : application/pdf, 1 Pages, 658.49KB

PDF [download]

2020-05-15 FAO LEDStuntDrone IM

LED STUNT DRONELED STUNT DRONEINSTRUCTION MANUALAGES 14+BEFORE USE, READ ALL WARNINGS AND INSTRUCTIONS IN THIS MANUAL.BCFAO® and FAO Schwarz® names and logos are trademarks or registered trademarks. All rights reserved. www.fao.com ©2020 MerchSource, LLC. Irvine, CA 92618 For customer support please call 1-800-668-5593. For technical support, please visit www.merchsource.com or call 1-800-374-2744.The artwork and design of this manual are protected by US copyright law and may not be reproduced, distributed, displayed, published or used for any purpose without prior written permission. It is not permitted to alter, remove or reproduce any trademarks or copyright notice from this manual.Printed in ChinaKEEP THIS INSTRUCTION MANUAL AS IT CONTAINS IMPORTANT INFORMATION FOR FUTURE REFERENCE.Due to continuous product improvements, the picture on the manual may differ slightly from the actual product.Adult Assembly RequiredWARNING:CHOKING HAZARD - Small Parts.Not for children under 3 years.INTRODUCTIONCongratulations on your purchase of the LED Stunt Drone. It's time for some fun. This drone is capable of total controlled flight, fly up/down, left/right, and pitch forward or backward, on 6 axis gyro stabilization with a control range of 150 feet. Includes USB charging cable, replacement blades and for auto orientation, auto take-off and auto landing control. Included, is a 380 mAh Li-po drone battery. The remote controller requires requires 3 AAA 1.5V batteries (not included). Alkaline batteries are recommended.Please read all instructions and warnings in this manual prior to using your LED Stunt Drone, and keep this instruction manual as it contains important information for future reference. Adult assembly and a Phillips screwdriver will be required for battery installation.TABLE OF CONTENTSGeneral Warnings Contents Remote Battery installation and Charging Battery Replacing Propellers Remote Overview Operating Drone Operating Other FeaturesPage 2 Page 3 Page 4 Page 5 Page 6 Page 7 Page 8 Page 9INTRODUCTION1. PREPARE FOR FLIGHT· Drone must be charged before each use (Cable included). · Indicator light on USB plug will turn off when fully charged. · Install batteries in remote.2. PAIR YOUR DRONEBefore each flight pair the remote with the drone: 1. Turn your drone on and place on a flat, level surface. 2. Turn on the remote. 3. Push the left stick up and then down. 4. Repeat steps 1 and 2 if necessary.3. CALIBRATE· Move both joysticks diagonally in toward the middle of the remote.4. REMOTE CONTROL OVERVIEWPractice flying your drone below 10 feet and at low speeds until comfortable with all controls to avoid unnecessary damage or injury. · Left joystick: Up/Down controls elevation. · Right joystick: controls flight direction. · Direction Trim: Use to eliminate drift . To cut power to drone, move left joystick to down position.GENERAL WARNINGSSAFETY WARNINGS· Not recommended for children under 14 years of age. As with all electrical products, precautions should be observed during handling and use to reduce the risk of electrical shock.· Adult supervision is required at all times. · Never fly drones above or near people, sudden changes in wind or other conditions could lead to unexpected crashes. · Always use caution when flying drone vehicles, obey relevant laws, respect the privacy and property rights of others. · The drone shall never be modified or used for anything except its intended purpose. · Before each use, an adult should review the product and battery to determine that no damage or hazards exist. · DO NOT TOUCH SPINNING PROPELLERS. · Do not allow anything to intentionally make contact in any way with spinning propellers or prevent contact withspinning blades by turning off remote prior to handling drone. · Use caution and pay attention to your surroundings while operating drone. · Do not fly drone into animals, people, or inanimate objects. · Keep drone away from power lines, buildings, trees, public areas, and any other potentially hazardous areas. · Do not operate in rain, heavy wind, and or any type of severe weather. · Do not land drone on wet surfaces. · Never touch or allow others to touch drone while it is flying. · Always turn drone off when it is not in use. · Always fly drone in large open areas.CONTENTSLED DroneDrone ControllerWARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accord- ance with the instructions, may cause harmful interference to radio communications. However there is no guarantee that interference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help.Fly-aways are the responsibility of the individual pilot and will not be replaced by the manufacturer.24 Replacement Propellers.USB Charger Cable3REMOTE BATTERY INSTALLATIONAAAThere is a risk of fire and personal injury if Li-Po battery is punctured, damage or misused. · Never expose battery to extreme temperatures or moisture. · Do not subject battery to strong impacts. · Always keep battery away from flammable materials. · Only use manufacture specified battery(ies), charger(s) and/or adapter, if applicable,specified by the manufacturer. · Battery is not serviceable. · Let battery cool to room temperature before charging. · While charging, never leave battery unattended. · Recycle or dispose of battery according to federal, state and local laws.KEEP THIS PACKAGING FOR REFERENCE AS IT CONTAINS IMPORTANT INFORMATION.1. Slide open the remote's battery compartment.2. Install 3 "AAA" batteries as shown in thediagram above. 3. Replace and close battery compartment.BATTERY WARNING:· Do not mix old and new batteries. · Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries. · Insert batteries using the correct polarity. Do not short-circuit the supply terminal. · Remove batteries when not in use. Recycle or dispose of exhausted batteries according tofederal, state, and local laws. Do not dispose of batteries in a fire - they may leak or explode. · Only use manufacture specified battery(ies), charger(s) and/or adapter, if applicable,specified by the manufacturer. · Always use, replace, and recharge (if applicable) batteries under adult supervision.KEEP THIS PACKAGING FOR REFERENCE AS IT CONTAINS IMPORTANT INFORMATION.Charging Battery1. Turn off the drone before charging. 2. Connect the battery charger cable to the charging port on the drone. 3. Connect USB connector to the power source.Note: The Battery Charger will light up when it is charging the battery and turn off when the battery is fully charged.Connect the battery charger to droneInsert the USBconnector into a USB1power source4REPLACING PROPELLERSA BA B· Only an adult should replace blades. To remove, pull up the blades directly. · Replace propellers by following the diagram. · Each blade spins differently. Blade B spins counter clockwise and Blade A5AAA AAA5 FEETREMOTE OVERVIEWSPEEDSTUNTLIGHT EFFECTF TRIMAUTO ORIENTATIONLIGHT ON/OFFTAKE OFFB TRIM LANDEMERGENCY STOPON/OFFR TRIM L TRIM6OPERATING DRONEStep 1 - Pre-Flight Checklist. 1. Read all warnings and instructions. 2. Install remote batteries, page 4. 3. Charge batteries, page 4. 4. Make sure that the drone and remote are powered off.Step 2 - Choosing a location.· Drone is designed to be flown indoors and outdoors.· Always make sure you have enough space to fly drone. · Always follow warnings, page 2.10 FEETStep 3 - Pre-Flight · Make sure your remote is off. · Push the power button on top of the drone and hold on 1-2s until LED lights on. · Place drone on a flat even surface. For ease of control, the blue lights should be toward you. · Turn on the Remote controller.Push the left stick up and then down. · The drone's lights will flicker during the pairing process and then remain on once it has paired.Step 4 - Lift Off.LIGHT EFFECTSPEEDAUTO ORIENTATIONLIGHT ON/OFFTAKE OFFEMERGENCY STOPPress the Auto Take off Button.ORLIGHT EFFECTAUTOLIGHT ON/OFFSlowly and carefully press the Throttle stick. Drone will begin to elevate.7OPERATINGStep 5 - Operating Drone in Flight.STUNTSPEEDSTUNTF TRIMLIGHT EFFECTF TRIMSTUNTON/OFFB TRIM LANDR TRIM L TRIMAUTO ORIENTATIONLIGHT ON/OFF ON/OFFTAKE OFFEMERGENCY STOPB TRIM LANDF TRIMR TRIM L TRIMON/OFFB TRIMR TRIM1. Follow this step if your drone begins to drift during take off or during flight.2. Use the Throttle Joystick to increase or decrease your elevation.A. Drone drifts backwards: Press the Forward Trim Button.B. Drone drifts forwards: Press the Backwards Trim Button.C. Drone drift right: Press the Left Trim Button.D. Drone drift left: Press the Right Trim Button.3. Use the Multi Directional Joystick to move forwards, backwards or side to side.4. Stunts - Press the Stunt Button then press the Multi Directional Joystick in the direction you want to complete a stunt.Note: 1. The stunt function may be disabled if the drone battery power is low. 2. Hover the drone at or above 10 feet before attempting a stunt.Step 6 - Landing DroneSPEEDSTUNTLIGHT EFFECTF TRIMStep 7 - Retrieving DroneOFFONAUTO ORIENTATIONLIGHT ON/OFFTAKE OFFB TRIM LANDR TRIM L TRIM1. Lower drone to 20 feet or less then press the Auto Land button. Use the Multi Directional Joystick to maneuver drone. Or Push the left joystick down until the drone landing.2. In the event the blades will not stop spinning, you can perform an emergency stop.1. Turn off your remote by pressing the Power Button. This will stop you from accidentally turning the propellers on.2. Make sure the propellers have stopped spinning then pick up your drone.Note: You will need to pair your drone again before your next flight, (part 1 of step 4).8OTHER FEATURESAuto OrientationSTUNTF TRIMON/OFFAUTO ORIENTATIONTAKE OFFEMERGOEN/COYFF STOPB TRIMPress the Auto Orientation Button to turn the mode ON and then again to turn off.· In this mode, the drone will always move in the direction you press the Multi Directional Button no matter which way the drone faces.· To stop blades in case of an emergency.When drone is in auto orientation mode, the drone will orient to the user (remote), no matter what direction the drone is facing.· Press the Orientation button. Remote will beep every 6 seconds to indicate it is in Auto Orientation mode. · Push the right stick up will send the drone away from the user, push left will move left, etc. · Press Auto Orientation button to exit mode.Tips· Do not crash drone into sand or dirt. Drone gears may become clogged. · When first learning to fly, practice lifting off and hovering. · Stay several feet from walls and buildings.9